News

From October 2012 we expand the assortment of Funnel adapters ST line for Ultrasonic level meters ULM. Funnel adapters increases the radiation directivity of acoustic waves, improves reception of weak echoes and reduces the risk of false reflections. They are intended for level meters ULM-53 and ULM-70 with measuring range to 2 and 6 m. Now we offer the new plastic nuts G1" and G1½" for ULM level meters.

The unit MGU-800 is intended for viewing, recording and evaluation of various physical quantities. Through 3.5" touchscreen display the operator can obtain complete overview of all measured variables and six of them can be viewed simultaneously. The unit provides up to 16 analog inputs and is able to independently control up to 16 relay outputs. Also allows you to record analog waveform signals of all inputs and display them in different graphics modes with possible transmission through ...

From January 2012 we deliver level meters ULM-70 with updated firmware. Unlike previous versions the level gauges have new function "CLONE SETTINGS" intended to transfer the setting to another level gauge. The function "UNITS" allows viewing even in imperial and U.S. physical units (Fahrenheit, gallon, barrel, foot, inch etc.). The new firmware also simplifies the basic level meter settings (min and max levels).

Since January 2012, the hydrostatic level meter HLM-25S is newly available in three-wire version with voltage output 0 .. 10V.

In "Download" section we can found Map of Dinel products application. This table is for orientation only. Specific type for particular application must be consulted with the producer. Each application is influenced by many aspects.

Thru-wall level sensors series GPLS-25 are intended for liquid level detection in glass and plastic gauge pipes, tubes, various canisters, containers, etc. It fully replaces older type of GPLS-25. Available in two versions with a straight electrode (for straight wall vessels) and prismatic electrode (for the gauge pipes, tubes). Setting of the switching mode and sensitivity is done using magnetic pen. Sensors are equipped with LED state indication.

Capacitive level sensor CLS-23S is intended to detect water level in wells, boreholes or tanks with immersion depth up to 100 m. It's fully replaces the old type CLS-18S. Its installation is very simple without setting. The sensor has a protective stainless steel basket to prevent damage of the electrode. Two-wire electrical connection directly to the relay circuit or to control system (PLC).

Capacitive level meter CLM-40 is intended for accurate level measurement in diesel tanks of trucks, construction and agricultural machinery, locomotives, etc. Fitting in the tank is performed using a 5-hole flange. There are versions with current (4 .. 20 mA) or voltage (0 .. 10 V) output. The level meter has no setting elements and so its installation is very simple. Electrode length is arbitrary (up to 1 m).